Question:
Simple question maybe. How is the best way to dry wood cut from trees? I have several around the farm here, ranging from Pecan to Oak. During fall we trim them up and think they would be a cheap supply. I have heard several ways using a coat of latex over the cut ends to using denatured alcohol. How you would use that I have not a clue. Any thoughts?
Submitted by Dave L.
Answer:
Wood can be air dried. To do that you should cut the log into planks as soon as you can after the tree is down. Seal the ends with latex paint to prevent moisture from escaping the end grain too quickly. Then stack the wood up using stickers as shown in this video.
If you want to keep the trimmed parts as branches, perhaps for bowl blanks, you should still seal the ends. It’s nearly impossible to get a log to dry without cracking, so they’re typically turned green (wet). You can use products like Pentacryl to stabilize the material. Follow the manufacturer’s instructions. I’m not familiar with using denatured alcohol on green wood.
George
Do you have a question for WWGOA? Ask us on Facebook or email editor@wwgoa.com. Note: questions may be edited for clarity and relevance.
I want to save the bark on rough cut shelf what do I use
The exact information I was seeking
George; I had a friend cut down 8 Pecan trees. He delivered the logs to my home with the branches removed. I had a friend with a portable saw mill come 2 days later and cut them into lumber. I stacked them up with space between the boards for air circulation. When done I had a rather large pile of 6 to 8 inch wide boards 8 to 10 feet in length covered from the elements. I started using the boards after resting a little over 2 years. Before the logs were cut into boards, I used endgrain sealer, purchased from Woodcraft, on both ends of the logs. When I started using them. I found the moisture content was 9 to 11 percent which is what the ambient air content was. There was enough weight on top to keep the boards very flat during the drying process. But, I had no way of preventing the boards from curling. Sitting on their edge, some of the boards looked like arches. Some six years since this project of drying was undertaken, I have used all but 13 of the boards and have not had to discard any. I cannot think of any way to stop that type of warpage from happening.
If you do not paint the end of a board that you are drying right away or coat it with something to preserve it...can this be done later to prevent the board from spliting or is it too late?
Is there a rule of thumb for the time span you can expect to air dry lumber, before being used for projects?
I carve wood. What is the best way to dry limbs? I don't want planks. Do I paint or seal the cut ends?
I am just starting to get into turning and got some large apple tree rounds that I want to process into bowl blanks. I sealed the ends with Anchorseal but don't know if I should air dry the rounds and cut them into bowl blanks and air dry those. Also , if I cut them into bowl blanks, do I seal the whole blank or just the grain ends ?
How low should the moisture content be before using it?
How to dry bowl blank in microwave?
Is pentacryl recommended for food grade bowls?